covid-19, offer of assistance 

Assuming that I fix my 3D printer today, I am going to start churning out facemasks in the below model. They are intended to be filled with cut-up A/C filters, etc. They can supposedly be fitted to your face by microwaving them a bit to soften them, and be sterilized by putting them in the oven. I have not tested this yet. MOre to come

Everyone who can read this can get one from me for the cost of shipping. I am in Texas, USA. DM's open.

thingiverse.com/thing:4222563

covid-19, offer of assistance 

@Garrison are you sure using heat to mold it so it fits the face better is a good idea? depending on the type of plastic it's going to release volatile organic compounds right in front of your airways, and I assume you have to breathe through it to test the fit?

covid-19, offer of assistance 

@emptyfortress PLA is entirely organic and non-toxic

Follow

covid-19, offer of assistance 

@Garrison it still gives off VOCs, even if it's in smaller quantities than, say, ABS, there's still going to be exposure to things like methyl methacrylate, a known eye irritant

I mean, I feel this is something your users should know about so they can make an informed decision, I know I wrote all the things to be aware of I could think of with the mask sewing pattern I posted

covid-19, offer of assistance 

@emptyfortress you're fearmongering

Sign in to participate in the conversation
Radical Town

A cool and chill place for cool and chill people.